Ruijie Community

Title: AnyLink abnormal [Print this page]

Author: adi25yusro@gmai Time: 2025-4-10 23:37
Title: AnyLink abnormal
I have an issue with ruijie AnyLink, the topology using mesh.

I have 4 unit Reyee Gateway:
siteA: with ISP A
siteB: with ISP A

siteC: with ISP B

siteC: with ISP C

- Tunnel from siteA to siteB : normal
But if connected to other site with diferent ISP: Abnormal
the impact is, when i access to some Server/NVR from different site, suddenly latency change to high (more then 2000ms)
Is is possiblity due to different ISP or is there any wrong configuration?.

Author: v-saul@ruijie.c Time: 2025-4-12 00:41
This issue can be due to the NAT type of connection, this is going to depends on the isp. From link detail you can check the NAT detection as follows

Depending on the scene the tunnel are going to fail or not

Regards!

Author: adi25yusro@gmai Time: 2025-4-12 09:04

TAC-Saul replied at 2025-4-12 00:41
This issue can be due to the NAT type of connection, this is going to depends on the isp. From link ...

Thankyou for explanation.
So that means, if one of the ISPs detects symmetric, NAT will fail.
How to change NAT type from symmetric?.
or only one solution is should change ISP?

Author: v-xiewenyu@ruij Time: 2025-4-12 13:51

Adi Yusro replied at 2025-4-12 09:04
TAC-Saul replied at 2025-4-12 00:41
This issue can be due to the NAT type of connection, this is goi ...

The NAT type is detered by your ISP, so yes the only one solution is should change ISP

Welcome to Ruijie Community (https://community.ruijie.com/)