Ruijie Community

Title: Mesh uplink to 2.4ghz [Print this page]

Author: Richard Time: 2025-7-17 23:06
Title: Mesh uplink to 2.4ghz
How to change my uplink mesh to use 2.4ghz instead of 5ghz?
I was using EW1200G-Pro.

Author: Trezan Time: 2025-7-22 17:36
Hello, Sir. What kind of equipment are you using? RAP or EW device?

Author: Prtechtips@gmai Time: 2025-7-25 11:10

Trezan replied at 2025-7-22 17:36
Hello, Sir. What kind of equipment are you using? RAP or EW device?

I was Using EW1200G-Pro for router and mesh.
So is there any way for me to change the uplink manually?
because the signal on 5Ghz (20 - 40 Mbps)is pretty bad while the 2.4 is a lot better (200+Mbps) between the main router and the node.

Author: lishujuan@ruiji Time: 2025-7-25 14:46

Richard replied at 2025-7-25 11:10
I was Using EW1200G-Pro for router and mesh.
So is there any way for me to change the uplink manua ...

Dear Customer，
The mesh function depends on automatic frequency band selection, with 5G being the priority. Could you try using a wired mesh or place the devices closer and try again.

Welcome to Ruijie Community (https://community.ruijie.com/)