Title: Cybrey FAQ [Print this page] Author: zhangqiao@ruiji Time: 2026-10-13 18:46 Title: Cybrey FAQ 1. What are the default addresses of Cybrey device？
CNC/ CS Switch /CAP default IP：10.20.40.42/20
CR gateway default IP（New version)：10.20.48.1/20
CR or SW mgmt port IP address: 10.20.30.42/20
All device default domain：setup.ruijie.com
Master device default domain:cnc.ruijie.com
Cybrey cloud url:https://cloud.ruijienetworks.com/ (You can log in directly using your Ruijie Cloud account.）
2. Does the Cybrey gateway or firewall support forming an SD-WAN network with the Reyee EG?
Yes, its support.
3. Does Cybrey switch web support VSU configuration?
Yes, its support.
4. Does the Cybrey gateway or firewall support Cloud management after forming an HA cluster?
Yes, its support. Currently, only the HA AP mode (Active-Passive) is supported, while the AA mode (Active-Active) is not supported.
5. Can Cybrey devices form a self-organizing network with Reyee or Ruijie devices?
Not supported. Cybrey products cannot discover and network with the following products:
• The Reyee devices including Reyee Gateways, Reyee switches and Reyee Wirelesses;
• The Ruijie devices including RG-NBR, Z-series firewalls and L-series device(e. g. WS6012-L, 820-L V3, CS86, etc.)
6.If a project on Cybrey Cloud started without CNC mode and needs to switch to CNC mode later, what should be done?
You need to create a new project, add the CNC equipment to the new project, and then add the equipment from the original project to the new project by merging networks within the new project.
7. Does CNC105 support centralized forwarding mode?
Not supported