Ruijie Community
Title: What Do I Do When the Device Is Suspended After the M8600-MPLS Card Is Inserted? [Print this page]
Author: admin Time: 2017-5-3 16:44
Title: What Do I Do When the Device Is Suspended After the M8600-MPLS Card Is Inserted?
What Do I Do When the Device Is Suspended After the M8600-MPLS Card Is Inserted?
Author: admin Time: 2017-5-3 16:45
Fault Symptom:
try to insert the ASE3 module into slot 4 and the chassis will be blocked, then we installed into module 8, check the output.
The console is suspended after the M8600-MPLS card is inserted and the displayed status is "resetting".
Solution:
1. Check the version.
Ctrl>version
Module information:
Slot-1 : 7200-2XG
Hardware version : A3.0
Original main file version : Firmware10.4(3) Release(118208)
BOOT version : 10.4 Release (118208)
CTRL version : 10.4 Release (118208)
Slot-2 : 7200-4XG
Hardware version : A3.0
Original main file version : Firmware10.4(3) Release(118208)
BOOT version : 10.3 Release (76833)
CTRL version : 10.4 Release (118208)
Slot-3 : 7200-4XG
Hardware version : A3.0
Original main file version : Firmware10.4(3) Release(118208)
BOOT version : 10.3 Release (76833)
CTRL version : 10.4 Release (118208)
Slot-5 : 7200-24G
Hardware version : A3.0
Original main file version : Firmware10.4(3) Release(118208)
BOOT version : 10.4 Release (118208)
CTRL version : 10.4 Release (118208)
Slot-6 : 7200-24
Hardware version : A3.0
Original main file version : Firmware10.4(3) Release(118208)
BOOT version : 10.4 Release (118208)
CTRL version : 10.4 Release (118208)
Slot-8 : 7200-ASE3
Hardware version : A1.0
Original main file version : FirmwareRGNOS 10.3.00(3b12), Release(40793)
BOOT version : 10.3 Release (40793)
CTRL version : 10.3 Release (40793)
2. It is preliminarily judged that the version is too old and not compatible with the device. Attempt to upgrade cards in CTRL mode.
Ctrl>upgrade -slot 8
These images in linecard will be updated:
Slot image linecard
------ ----- ------------------------
8 CTRL 7200-ASE3
MAIN 7200-ASE3
-----------------------------------------------
(Slot 8): Installing MAIN
(Slot 8): Download imageVerify the image .[ok]
Upgrade file to Module(s) in slot: [8]
Please wait......
Upgrade file to Module in slot [8] OK!
(Slot 8): MAIN installed.
(Slot 8): Install finish in slot 8 (7200-ASE3).
3. Restart the device.
Note: Restart the entire device and check whether the version is successfully upgraded under the main program. Otherwise, the version is still the earlier version in CTRL mode.
Ctrl>reload
Do you still want to reload system?(y/N):
SYS-5-RESTART: The device is restarting. Reason: Restart the whole system!.
4. After checking that the version is upgraded successfully under the main program, the fault is rectified and the device is restored to the normal state.
| Welcome to Ruijie Community (https://community.ruijie.com/) |
Powered by Discuz! X3.2 |
