Unable to Access Management Interface on L2 Switch via Trunk Connection
|
Edited by tuan2tech@gmail.com at 2025-10-20 09:17 Description: I am using two Ruijie CS86 switches: Switch 1 (Layer 3): Configured with 10 VLANs and DHCP enabled. Switch 2 (Layer 2): Has a management IP interface accessible via eWeb. I configured a trunk port on the Layer 3 switch (VLAN ID 1, allowing all VLANs) and connected it to port 1 on the Layer 2 switch. After connecting the trunk, I cannot access the management IP of the L2 switch. Request: Please guide me on how to configure the Layer 2 switch so it can obtain an IP address (via DHCP or static) for management access through the trunk connection. |
|
Dear What is the model of your L2 switch? Have you also configured the corresponding port for Trunk mode on the L2 switch? |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
