Mesh uplink to 2.4ghz
|
How to change my uplink mesh to use 2.4ghz instead of 5ghz? I was using EW1200G-Pro. |
|
Hello, Sir. What kind of equipment are you using? RAP or EW device? |
Trezan replied at 2025-7-22 17:36 I was Using EW1200G-Pro for router and mesh. So is there any way for me to change the uplink manually? because the signal on 5Ghz (20 - 40 Mbps)is pretty bad while the 2.4 is a lot better (200+Mbps) between the main router and the node. |
Richard replied at 2025-7-25 11:10Dear Customer， The mesh function depends on automatic frequency band selection, with 5G being the priority. Could you try using a wired mesh or place the devices closer and try again. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
