Cybrey FAQ

1. What are the default addresses of Cybrey device？
CNC/ CS Switch /CAP default IP：10.20.40.42/20
CR gateway default IP（New version)：10.20.48.1/20
CR or SW mgmt port IP address: 10.20.30.42/20
All device default domain：setup.ruijie.com
Master device default domain:cnc.ruijie.com
Cybrey cloud url:https://cloud.ruijienetworks.com/ (You can log in directly using your Ruijie Cloud account.）

2. Does the Cybrey gateway or firewall support forming an SD-WAN network with the Reyee EG?
Yes, its support.

3. Does Cybrey switch web support VSU configuration?
Yes, its support.

4. Does the Cybrey gateway or firewall support Cloud management after forming an HA cluster?
Yes, its support. Currently, only the HA AP mode (Active-Passive) is supported, while the AA mode (Active-Active) is not supported.

5. Can Cybrey devices form a self-organizing network with Reyee or Ruijie devices?
Not supported. Cybrey products cannot discover and network with the following products:
• The Reyee devices including Reyee Gateways, Reyee switches and Reyee Wirelesses;
• The Ruijie devices including RG-NBR, Z-series firewalls and L-series device(e. g. WS6012-L, 820-L V3, CS86, etc.)

6.If a project on Cybrey Cloud started without CNC mode and needs to switch to CNC mode later, what should be done?
You need to create a new project, add the CNC equipment to the new project, and then add the equipment from the original project to the new project by merging networks within the new project.

7. Does CNC105 support centralized forwarding mode?
Not supported

8. Does CNC106 support VAC?
Not supported

9.What devices can be added to Cybrey cloud's third-party device management and monitor feature?
Please refer to the documentation instructions for third-party device management in the Cloud help center: https://cloud-as.ruijienetworks.com/help/cybrey/#/ArticleList? id= 2726fea7d9e144f89b47e6434755a7c9

10.Cybrey solution cookbook link
https://www.ruijie.com/en-global/resources/preview/ruijie-cybrey-product-solution-implementation-cookbook/